Vehicle Personalization
Memory
Seat
If
your vehicle has this
feature, then the controls
for the memory function
are located on the
driver’s door.
These buttons are used to program and recall memory
settings for the driver’s seat, both the driver’s and
passenger’s outside mirror, and the radio station
presets. The settings for these features can be
personalized for both driver 1 and driver
2.
Driver
1
or
driver 2 corresponds to the memory buttons labeled
land
2
on the driver’s door.
To store your memory seat, mirrors and radio presets,
do the following:
1. Adjust the driver’s seat (including the seatback
recliner, lumbar, and side wing area), both of the
outside mirrors, and the radio station presets to your
preference.
2.
Press and hold the
1
or
2
(for driver lor
2)
button
of the memory control for three seconds.
A
double
chime will sound to let you know that the position
has been stored.
To repeat the procedure for a second driver, follow the
preceding steps, but press the other numbered
memory control button.
Each time button
1
or
2
is pressed and released while
the vehicle is in PARK
(P),
a single chime will sound and
the memory position will be recalled.
If
you use the unlock button on the remote keyless entry
transmitter to enter your vehicle, the preset driver’s
seat, mirror positions and the radio station presets will
be recalled
if
programmed to do
so
through the
Driver Information Center
(DIC).
The numbers on the
back of the transmitters,
1
or
2,
correspond to the
numbers on the memory controls.
2-67
To Next Page
Loading...
Need help?
General
