A. Windshield Washer Fluid Reservoir. See “Adding
Washer Fluid” under Windshield Washer Fluid
on page 5-39.
B. Battery. See Battery on page 5-42.
C. Underhood Fuse Block. See Underhood Fuse Block
on page 5-94.
D. Remote Positive (+) Terminal. See Jump Starting on
page 5-43.
E. Pressure Cap. See Pressure Cap on page 5-28.
F. Power Steering Fluid Reservoir. See Power Steering
Fluid on page 5-38.
G. Engine Oil Dipstick. See “Checking Engine Oil”
under Engine Oil on page 5-17.
H. Engine Oil Fill Cap. See “When to Add Engine Oil”
under Engine Oil on page 5-17.
I. Automatic Transaxle Fluid Dipstick. See “Checking
the Fluid Level” under Automatic Transaxle Fluid
on page 5-23.
J. Brake Master Cylinder Reservoir. See “Brake Fluid”
under Brakes on page 5-40.
K. Engine Air Cleaner/Filter. See Engine Air
Cleaner/Filter on page 5-21.
L. Coolant Recovery Tank. See “Checking Coolant”
under Cooling System on page 5-31.
Engine Oil
Checking Engine Oil
It is a good idea to check your engine oil every time you
get fuel. In order to get an accurate reading, the oil
must be warm and the vehicle must be on level ground.
The engine oil dipstick handle is a yellow loop. See
Engine Compartment Overview on page 5-12 for
the location of the engine oil dipstick.
1. Turn off the engine and give the oil several minutes
to drain back into the oil pan. If you do not do this,
the oil dipstick might not show the actual level.
2. Pull out the dipstick and clean it with a paper towel
or cloth, then push it back in all the way. Remove it
again, keeping the tip down, and check the level.
5-17
To Next Page
Loading...
Need help?
General
