To tilt the wheel, hold the steering wheel and pull the
lever. Move the steering wheel to a comfortable
level, then release the lever to lock the wheel in place.
Turn Signal/Multifunction Lever
The lever on the left side of the steering column
includes the following:
• G Turn and Lane Change Signals. See Turn and
Lane-Change Signals on page 3-7.
• 53 Headlamp High/Low-Beam Changer. See
Headlamp High/Low-Beam Changer on page 3-8.
• Flash-to-Pass. See Flash-to-Pass on page 3-8.
• N Windshield Wipers. See Windshield Wipers on
page 3-9.
• L Windshield Washer. See Windshield Washer
on page 3-10.
For information on the exterior lamps, see Exterior
Lamps on page 3-14.
Turn and Lane-Change Signals
The turn signal has two upward (for right) and two
downward (for left) positions. These positions allow you
to signal a turn or a lane change.
To signal a turn, move the lever all the way up or down.
When the turn is finished, the lever will return
automatically.
To signal a lane change, raise or lower the lever for
less than one second until the arrow starts to flash. This
will cause the turn signals to automatically flash
three times. It will flash six times if the tow-haul mode is
active. Holding the turn signal lever for more than
one second will cause the turn signals to flash until you
release the lever. The lever will return by itself when
it is released.
3-7
To Next Page
Loading...
Need help?
General
