Getting to Know Your Avalanche
4
Heated Front Seats (if equipped)
This feature allows you to heat the front
seatbacks and seat cushions simultane-
ously or just the seatbacks. The controls
are located on the driver and front pas-
senger door panels.
Select a heat setting for both the
seatback and seat cushion
• Press and release the horizontal
button (“A” above) until the indicator
light shows the desired setting.
Select a heat setting for the seatback
only
• Press and release the vertical button
(“B” above) until the indicator light
shows the desired setting.
See Section 1 of your Owner Manual.
Passenger Automatic Locking
Restraint (ALR)
The safety belt is designed to lock
during an accident, but it will also lock if
it is pulled out all the way during initial
buckling, and you may be unaware that
this has happened. If the safety belt
does lock, unbuckle it and allow it to
retract fully, then pull it out and re-buckle
the belt.
See Section 1 of your Owner Manual.
Power Lumbar Front Seats
(if equipped)
A
B
Adjust lumbar
support
• Press the front
or rear of the
control located
on the side of
the seat cush-
ion near the door. Release at the pre-
ferred setting.
Adjust outer portion of lumbar seat-
back area
• Press the top or bottom of the lumbar
control. Release at the preferred
setting.
See Section 1 of your Owner Manual.
A chime will sound and the safety belt
light ( ) will be illuminated and flash
for several seconds when the ignition
key is turned to Run or Start, or at
any time the vehicle is running, and the
driver’s safety belt is not buckled.
If your vehicle is equipped with the pas-
senger sensing system, the chime will
sound and a message will be displayed
on the Driver Information Center for
several seconds if the passenger’s
safety belt is not buckled under the
same conditions.
See Section 3 of your Owner Manual.
Driver and Front Passenger
Safety Belt Reminder
(if equipped)
To Next Page
Loading...
