Getting to Know Your Aveo
12
To set the Hold mode:
• Place the shift lever in the gear range
you want to hold.
• Press the HOLD button located on
the shift lever console. (The HOLD
indicator light on the Secondary
Information Center will illuminate.)
• Press the button again to turn off the
Hold mode and return to normal auto-
matic transaxle operation.
See Section 2 of your Owner Manual.
Automatic Transaxle Hold
Control Mode (if equipped)
Integrated with the optional automatic
transmission, this feature gives the driv-
er complete control over the transmis-
sion gear selection.
When Hold Control is selected in the “D”
position, the transmission is held in 3rd
gear, which locks out overdrive (4th
gear) and provides additional torque and
responsiveness at most higher speeds.
This allows for engine braking during
higher speed descents and decelera-
tions. It also reduces/eliminates wheel-
spin when starting out on snow or ice.
Similarly, if Hold Control is selected in
the “2” position, the transmission will
start in 2nd gear (instead of 1st), helping
reduce wheelspin when starting out on
slippery surfaces.
Note: Since placing Hold Control in the
“D” position locks the transmission in
3rd gear and prevents downshifts to
2nd or 1st gear, acceleration from a
standstill or near standstill on dry pave-
ment will be slower than expected. Hold
Control should be deselected during
these situations.
Reverse Lockout Feature
(Manual Transaxle)
This feature prevents the engagement of
Reverse (R) gear when the vehicle is
moving forward.
To shift into Reverse (R), depress the
clutch pedal; then lift up the ring on the
shift lever and shift into Reverse (R).
Slowly release the clutch pedal while
pressing the accelerator.
See Section 2 of your Owner Manual.
Note: Shifting into Reverse (R) gear
while your vehicle is moving forward
could damage the transaxle. Shift into
Reverse (R) only after the vehicle is
stopped.
To Next Page
Loading...
Need help?
General
