2009 Chevrolet Aveo
|
Aveo, Wave, G3, Barina (VIN S/T) Service Manual
|
Engine
|
Engine Controls and Fuel - 1.6L (LXT)
|
Repair Instructions
| Document ID: 2098052
Manifold Absolute Pressure Sensor Replacement
Removal Procedure
Warning: Refer to Battery Disconnect Warning in the Preface section.
1. Disconnect the negative battery cable.
2. Remove the manifold absolute pressure (MAP) sensor electrical connector.
3. Disconnect the vacuum hose.
4. Remove the MAP sensor bolt.
5. Remove the MAP sensor.
Installation Procedure
Caution: Refer to Fastener Caution in the Preface section.
© 2010 General Motors Corporation. All rights reserved.
http://localhost:9001/si/showDoc.do?docSyskey=2098052&pubCellSyskey=124942&pubO