Chevrolet Equinox 2021 - Taillamps; License Plate Lamp

Chevrolet Equinox Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-
14420010) - 2021 - CRC - 7/29/20
270 Vehicle Care
Taillamps
Driver Side Shown, Passenger Side Similar
1. Sidemarker
2. Stoplamp/Taillamp/Rear Turn Signal
To replace one of these lamps:
1. Open the liftgate. See Liftgate 0 17.
2. Remove the two screw covers from the
taillamp assembly.
3. Remove the two screws securing the
taillamp assembly.
4. Pull the taillamp assembly out of the
vehicle body.
5. Disconnect the lamp wiring harness.
6. Turn the bulb socket counterclockwise
and pull it out.
7. Pull the bulb straight out of the socket.
8. Install the new bulb.
9. Push the bulb socket in and turn it
clockwise.
10. Reverse Steps 2–5 to reinstall the lamp
assembly.
License Plate Lamp
Lamp Assembly
Bulb Assembly
1. Bulb Socket
2. Bulb
3. Lamp Assembly
To replace one of these bulbs:
1. Open the liftgate partway. See Liftgate
0 17.
2. Push the lamp assembly outboard to
remove.
3. Pull the lamp assembly down to remove
it from the liftgate.
4. Turn the bulb socket (1) counterclockwise
to remove it from the lamp assembly (3).
5. Pull the bulb (2) straight out of the bulb
socket (1).