3-14 Seats and Restraints
To install:
1. Locate the anchor loop on the
rear outboard seatback, near
the top.
2. Attach the comfort guide to the
anchor loop by threading the
hook through the loop.
3. Place the guide over the belt,
and insert the two edges of the
belt into the slots of the guide.
4. Be sure that the belt is not
twisted and it lies flat. The
elastic cord must be behind the
belt with the plastic guide on the
front.
{
Warning
A safety belt that is not properly
worn may not provide the
protection needed in a crash. The
person wearing the belt could be
seriously injured. The shoulder
belt should go over the shoulder
(Continued)
To Next Page
