1-22 In Brief
2. Open the rear hatch, lift the load
support floor covering (A), and
remove the charge cord (D). It is
located near the tire sealant and
compressor kit (C). Pull up on
the charge cord handle (D) to
release it from the handle
clip (E). Lift the charge cord up
and rearward to remove it from
the vehicle. The vehicle plug (B)
is stored as shown.
3. Plug the charge cord into the
electrical outlet. See Electrical
Requirements for Battery
Charging on page 9‑52. Verify
that the charge cord status
indicators are both green. See
Charge Cord on page 9‑50 for
more information.
4. Then plug in the vehicle plug of
the charge cord into the charge
port on the vehicle. Verify that
the charging status indicator
illuminates on top of the
instrument panel and a horn
chirp occurs. See Charging
Status Feedback on page 9‑47
for more information.
5. To arm the charge cord theft
alert, lock the vehicle with the
RKE transmitter. To disable this
feature, see “Charge Cord Theft
Alert” in Vehicle Personalization
on page 5‑53.
End Charge
1. Unlock the vehicle with the RKE
transmitter to disarm the charge
cord theft alert.
2. Unplug the vehicle plug of the
charge cord from the vehicle by
squeezing the vehicle plug lever
and pull to remove.
3. Close the charge port door by
pressing firmly in the center to
latch properly.
4. Unplug the charge cord from the
electrical outlet.
To Next Page
Loading...
