Cheyenne HAWK THUNDER - Setting Piercing Frequency; Loading Ink into the Machine

46 Cheyenne HAWK, HAWK SPIRIT & HAWK THUNDER
6.2 Setting the piercing frequency
CAUTION
Risk of injury due to high piercing
frequency
If the piercing frequency is too high,
the skin can be cut.
E Always start at a low piercing
frequency, e.g. 70.
E Switch on the power supply of
theCheyenne power unit.
E Set an appropriate piercing frequen-
cy.
The piercing frequency can be
adjusted in 10 increments using
thearrow keys. Thepiercing frequency
must suit the characteristics of
the customer's skin, the needle
protrusion and piercing depth when
working, as well as the operating
speed.
6.3 Loading with ink
E Immediately before use, dip the tip
of the safety cartridge in the desired
color of ink for 2 to 3 seconds with
the unit running. Avoid contact with
the ink container.
The ink is picked up by the needles.
E Alternatively, the ink can be filled into
the opening on the safety cartridge
using a sterile pipette. Never fill in
too much ink so that it is not ejected
through the opening.
7 Cleaning and maintaining
the tattooing machine
CAUTION
Risk of short circuits and risk of mild
electric shocks
If components of the tattooing
machine are dismantled and cleaned
while still powered, there is a risk of
mild electric shock and damage to
theelectronics in the drive unit.
E Switch o the voltage supply to
the tattooing machine before
you begin with cleaning and
maintenance work.