10
Iron won’t heat.
• Plug iron into a working outlet.
• Select a temperature.
• Move or tilt the iron to reset.
Water is leaking.
• Too much water is in the Water Tank.
• Adjust steam to a lower setting.
• Steam button (
) has been pressed while the iron was cold.
Select a temperature and let iron preheat for 2 minutes.
• If dry ironing, make sure the Adjustable Steam Lever is in the
(Dry Iron) position.
Iron won’t steam.
• Ensure there is water in the Water Tank.
• Move the Adjustable Steam Lever to the
(Steam) position.
• Preheat for 2 minutes.
• Anti-drip feature will not allow steam when temperature
setting is in the dry range.
Twisted cord.
• If the iron cord should become twisted, unplug iron and let
cool. Hold iron cord in the middle of entire length. Let plug
and iron dangle freely until cord uncoils. This will extend the
life of the iron cord.
Troubleshooting
To Next Page
Loading...
