13
Iron won’t heat.
• Plug iron into a working outlet.
• Select a temperature.
• Move or tilt the iron to reset.
Water is leaking.
• Too much water is in the Water Reservoir.
• Steam button ( ) has been pressed while the iron was cold.
Select a temperature and let the iron preheat for 2 minutes.
Allow 5 seconds between Steam button ( ) presses for best
performance.
• If dry ironing, make sure the Adjustable Steam Lever is in the
(Dry Iron) position.
Iron won’t steam.
• Ensure there is water in the Water Reservoir.
• Move the Adjustable Steam Lever to the (Steam) position.
• Allow iron to reach temperature by waiting until “Ready!” is
displayed.
• Anti-drip feature will not allow steam when temperature
setting is too low.
Troubleshooting
To Next Page
Loading...
