13
Iron won’t heat.
• Plug iron into a working outlet.
• Select a temperature.
Water is leaking.
• Too much water is in the water tank.
• Make sure temperature dial is set in the steam zone (wool,
linen/cotton).
• Wait until Power/Ready Indicator Light stops flashing,
indicating that selected temperature in the steam zone has
been reached. Then, move Steam Shot Lever to (Steam
Iron).
• If dry ironing, make sure the Steam Shot Lever is in the
(Dry Iron) position.
Iron won’t steam.
• Ensure there is water in the water tank.
• Make sure temperature dial is set in the steam zone (wool,
linen/cotton).
• Wait until Power/Ready Indicator Light stops flashing,
indicating that selected temperature in the steam zone has
been reached. Then, move Steam Shot Lever to (Steam
Iron).
• Move the Steam Shot Lever to the (Steam Iron) position.
Water spitting from Steam Shot.
• Ensure Temperature Setting Dial is set to linen/cotton
(•••)
.
• Minor water spitting is normal during the start of steaming.
Troubleshooting
To Next Page
Loading...
