Chicago Electric 69360 User Manual (English)

Questions and Answers:

G
gonzalezwilliamJul 31, 2025
Why is my Chicago Electric Drill overheating?
- R
  Richard McbrideJul 31, 2025
  If your Chicago Electric Drill overheats, it might be due to several reasons. You might be forcing the tool to work too fast – allow it to work at its own pace. Check if the accessory is misaligned and correct it to the fence and/or table alignment. Ensure cutting accessories are sharp, and replace them if damaged. Also, the motor housing vents might be blocked. In that case, wear ANSI-approved safety goggles and a NIOSH-approved dust mask/respirator while blowing dust out of the motor using compressed air.
G
garciajeffAug 7, 2025
What to do if my Chicago Electric 69360 Drill will not start?
- I
  iblairAug 7, 2025
  If your Chicago Electric Drill won't start, first, check that the battery is properly installed and fully charged. If the battery is fine, the issue might be internal damage or wear, such as wiring or the trigger. In this case, have a technician service the tool.
D
Donna RyanAug 14, 2025
Why Chicago Electric 69360 performance decreases over time?
- M
  Micheal SuttonAug 14, 2025
  If the performance of your Chicago Electric Drill decreases over time, it could be due to a dull or damaged accessory. Keep cutting accessories sharp and replace them as needed. Another possible cause is worn or damaged carbon brushes. If this is the case, have a qualified technician replace the brushes.
N
Natalie CurtisAug 22, 2025
How to fix excessive noise in Chicago Electric 69360?
- H
  Hunter SinghAug 22, 2025
  If your Chicago Electric Drill is making excessive noise or rattling, this could indicate internal damage or wear, such as to the motor bearings. To resolve this, have a technician service the tool.