To Next PageTo Next Page
Need help?Do you have a question about the Chicago Electric 92146 and is the answer not in the manual?
General| Brand | Chicago Electric |
|---|---|
| Model | 92146 |
| Category | Pressure Washer |
| Language | English |
Step-by-step instructions for assembling the pressure washer components.
Plug the GFCI power cord into a grounded 120-volt electrical outlet.
Connect the spray wand extension to the gun securely.
Turn the power switch ON and raise the safety lock to use the trigger.
Press the power switch to OFF to shut down the unit.
Connect the high-pressure hose to the water outlet port.
Crucial safety advice to prevent injury, electric shock, fire, or serious harm.
Advice on alertness, proper attire, and avoiding accidental starts for user safety.
Rules for safe electrical connections and usage to prevent shock.
Keep clear of the nozzle and do not direct the stream at people or animals.
Improper grounding risks electric shock; consult an electrician if unsure.
Ensure tools are connected to properly grounded outlets for shock protection.
Ensure a minimum water supply of 3.4 GPM for correct operation.
Running without adequate water can cause pump vibration, noise, and damage.
Connect to water, turn on, and squeeze trigger to remove air before operation.
Use the GFCI plug for electrical shock protection; test and reset.
Never adjust the spray pattern knob unless the trigger is locked in the off position.
Turn off water supply and unplug the power cord from the outlet.
Squeeze the trigger to release any residual pressure in the system.
Always turn off the motor before shutting off the water supply to prevent pump damage.
Never disconnect the high-pressure hose while the system is pressurized; depressurize first.
Ensure the unit is off, unplugged, and depressurized before any inspection or maintenance.
