Chicago Pneumatic CP860 User Manual

Operator’s Manual
CP860, CP860E, CP860ES & CP860ESE
Die Grinder
To reduce risk of injury, everyone using, installing, repairing,
maintaining, changing accessories on, or working near this tool
must read and understand these instructions before performing
any such task.
WARNING

Chicago Pneumatic CP860 Specifications

General

Type	Die Grinder
Sound Level	82 dB
Vibration Level	2.5 m/s²
Power	0.3 hp
Air Pressure	90 psi
Collet Size	1/4 inch
Length	6.3 inches
Air Inlet Thread Size	1/4 inch NPT

Summary

Machine Type

Air Supply Requirements

Air Pressure and Connection

Supply tool with 90 psig clean, dry air. Connect to air line using specified sizes. Do not use quick coupler directly.

Lubrication

Lubrication Procedure

Use SAE #10 oil in an air line lubricator at two drops per minute, or add air motor oil daily.

Maintenance

Regular Inspection and Parts

Inspect air motor every three months. Replace worn parts. High wear parts are underlined in the parts list.

Technical Data

Tool Specifications

Details 1/4 in. or 6 mm collet, free speed 24,000 RPM, air pressure 90 psi, and air consumption 5 cfm.

Noise & Vibration Declaration

Emission Values

States sound pressure level and vibration values measured according to EN ISO standards.

Manufacturer's Limited Warranty

Warranty Terms

One-year warranty against defects in material and workmanship for new products purchased from authorized dealers.