14 15
10B. Insert the new batteries; check-
ing to make sure the polarity (+/-) on
the batteries matches the markings
on the product. Replace the battery
cover and tighten screw.
Fitting and/or Replacing Batteries
10B
10A. This Glider uses (4)1.5v AA
batteries. To replace the batteries,
loosen the screw holding the battery
cover with a Phillips screwdriver and
remove the battery cover.
10A
Fitting and/or Replacing Batteries
WARNING
The Glider requires 4 x “AA” 1.5 Volt alkaline type batteries (not included).
• Batteries must only be fitted by an adult.
• Always keep batteries and tools out of reach of children.
• Always remove spent batteries from the Glider to avoid the danger of possible
battery leakage.
• Remove batteries before putting product into storage for a prolonged period
of time.
• Only use alkaline batteries of the same type or equivalent to the type
recommended for the correct function of this product.
• Do not mix new and old batteries, or different types of batteries.
• Do not mix Alkaline, standard (carbon-zinc), rechargeable (ni-cad) batteries.
• Make sure batteries are inserted correctly.
• Do not burn or dispose of spent batteries into the environment. Dispose of
spent batteries at an appropriate differentiated collection point.
• Do not short-circuit the battery terminals.
• Do not attempt to recharge non-rechargeable batteries: they might explode.
• The use of rechargeable batteries is not recommended, since they could impair
the functionality of the Glider.
• If rechargeable batteries are used, take them out of the Glider before
recharging them. Batteries must always be recharged under adult supervision
To Next Page
Loading...
