Chilipepper CP9000 User Manual

Chilipepper CP9000
Installation Instructions
READ BEFORE INSTALLING:
* The Chilipepper is not designed to be connected with rigid piping like copper or
galvanized pipes. *Flexible hoses MUST be used.
* The Chilipepper fittings are designed for flexible hoses that have a rubber gasket to
make a water-tight seal.
* Do not use putty/pipe dope on the fittings for the Chilipepper.
*Teflon tape is ok, IF USED CORRECTLY, and the Teflon tape does not get inside the
pump head.
WARNING: Risk of electric shock. This pump is supplied with a grounding conductor
and a grounding-type attachment plug. To reduce the risk of electric shock, be
certain that it is connected only to a properly grounded grounding-type receptacle.
Package Contents Items Needed to Install the Chilipepper
The Chilipepper Appliance 110 Volt Outlet
Remote Key Fob Two Braided type hoses:
Brass Fitting with Temperature Sensor 3/8" Comp x 1/2" FIP
White Washer for Brass Fitting Wrench for the hoses
2 - Brass “T” Fittings
Hex Adjusting Tool
Screw Driver for Adjusting Temperature
Setting & Remote Codes
Helpful troubleshooting tips are at the back of this booklet.
Chilipepper Sales, Inc., 1410 Greg Street, Suite #408, Sparks, NV 89431
1

Chilipepper CP9000 Specifications

General

Brand	Chilipepper
Model	CP9000
Category	Water Pump
Language	English

Summary

Chilipepper CP9000 Installation Guide

Pre-Installation Warnings and Requirements

Crucial pre-installation warnings and guidelines for safe and correct setup.

Electrical Safety and Grounding

Warning about electrical shock hazard and grounding requirements.

Package Contents and Installation Tools

Lists all included package items and external items/tools required for installation.

Step 1: Connecting the Brass Fitting and Sensor

Attaching Brass Fitting and Sensor Cable

Detailed steps for connecting the brass fitting with a sensor and the sensor cable.

Important Notes on Pump Head and Packaging

Notes about water in the pump head and packaging of sensor components.

Step 2: Plumbing Under the Sink

Connecting Brass T-Fittings to Shut-off Valves

Disconnect old hoses and connect brass T-fittings to shut-off valves.

Connecting Hoses to Chilipepper and T-Fittings

Connect new hoses to the Chilipepper and then to the brass T-fittings.

Step 3: Priming and Finalizing Installation

Priming the Pump for Longevity

Essential procedure to remove air from the pump and lines for longevity and proper function.

Final Checks and First Time Activation

Final installation checks, plugging in, and first-time activation steps.

Step 4: Using and Adjusting the Chilipepper

Operating the Chilipepper with Remote Fob

Information on how to use the pre-set remote key fob for controlling the unit.

Adjusting Temperature and Remote Codes

How to adjust water temperature sensitivity and set remote control codes.

Chilipepper CP9000 Features and Troubleshooting

Key Features and Lock-Out Functionality

Highlights key features like moisture detection and operational limits like temperature lock-out.

Troubleshooting: Unit Not Starting

Steps to take when the Chilipepper unit does not start after pressing the button.

Troubleshooting: No Hot Water After Beeping

Solutions for when the unit beeps but fails to heat the water.

Chilipepper CP9000 Advanced Troubleshooting

Troubleshooting: Hot Water Not Reaching Sink

Addresses issues where hot water delivery is delayed or insufficient.

Troubleshooting: Hot Water in Cold Line

Discusses reasons and solutions for hot water appearing in the cold line when off.

Maintenance: Cleaning the Check Valve

Detailed instructions for cleaning and maintaining the spring-loaded check valve.