How to fix Chiltern Invadex Wispa 200 Mobility Aid hoist lacking power?
If your Chiltern Invadex Mobility Aid hoist lacks power, it's likely that the batteries are low. The suggested solution is to charge the batteries.
What to do if Chiltern Invadex Mobility Aid hoist cuts out while lifting?
If your Chiltern Invadex Mobility Aid hoist cuts out while lifting, the issue might be due to a twisted tape or exceeding the maximum load. Make sure the tape isn't twisted, remains vertical, and verify the weight on the hoist.
Why light on Chiltern Invadex Mobility Aid hoist does not work?
If the light on your Chiltern Invadex Mobility Aid hoist isn't working, make sure that the power is switched on at the mains point of charging.
What to do if Chiltern Invadex Wispa 200 Mobility Aid hoist lifts when down button is pressed?
If your Chiltern Invadex Mobility Aid hoist lifts when the down button is pressed, the lifting tape may be reversed on the spool. A service engineer is required to fix this.
Details the operation and types of 3, 5, and 7 button hand controls for the hoist.
Lists components of the hoist system, including hand controls with part numbers and quantities.
Details audible and visual signals for hoist status, including error codes and their meanings.
Covers common issues like hoist cut-out and tape reversal, with solutions.
Details compliance with EU directives for medical devices, EMC, and low voltage.
General| Brand | Chiltern Invadex |
|---|---|
| Model | Wispa 200 Series |
| Category | Mobility Aid |
| Language | English |
To Next Page