Mik-El / Chilton Page 9 of 26
Master Monitor. M3
A1 Master auxiliary output level control Pre channel fader. The AFL After Fade
Listen button (hold only) routes A1 to headphones, monitors and PFL meter.
A2 Master auxiliary output level control Pre or Post channel fader with AFL
switch
Osc. Low distortion test oscillator. LED indicates ON positions.
Talk back microphone gain control "G" is activated by "TB MIC" hold only
button and routed at Line Level to rear XLR connector when Slate A1 and A2
buttons are not assigned. Both Oscillator and Talk back can be used
independently or together. For example: assigning 40Hz and Talk back to slate
(group outputs) both track indent and fast wind search tone can be recorded.
Note: External Talk back is muted when any button is assigned.
MON control "G" is for control room or studio monitor loudspeaker level.
MUTE: This mutes the monitor output only.
PFL: Green LED indicates Monitors are in PFL mode via channel PFL buttons or
FL for Auxiliary Outputs.
TAPE: Selects stereo or mono tape returns.
MONO: Mono output summation of left and right groups.
HEADPHONE level control follows monitor output but is not muted.
"MIC" button also mutes Monitor signal in all modes.
Rear Panel:
A1 - A2 - TB See block diagram for connections.
Headphones: Jack 3 pole. Tip Left. Ring Right. Sleeve Common.
Parallel to jack socket on console front.
Mon: Monitor output wired as headphones.
TR Jack 3 pole. Tip Left. Ring Right. Sleeve Common.
To Next Page
Loading...