Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
protect reasonably against harmful interference in a residential installation. This
equipment generates, uses, and radiates radio frequency energy, if not installed and
used in accordance with the instructions, it may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
Suppose this equipment does cause harmful interference to radio or television
reception which can be determined by turning the equipment off and on. In that case,
the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna
-Increase the separation between the equipment and receiver
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
-Consult the dealer or an experienced radio/TV technician for help
NOTE: This device and its antenna(s) must not be co-located or operated in conjunction
with any other antenna or transmitter.
RF Exposure Statement
To maintain compliance with FCC's RF Exposure guidelines, this equipment should be
installed and operated with a minimum distance of 20cm from the radiator of your
body. This device and its antenna(s) must not be co-located or operated in conjunction
with any other antenna or transmitter.
To Next Page