7
How to operate your C60 Trident Chronograph Pro
For a superior water resistance your crown is
of the screw-in type. The crown should sit
ush to the case (position
1
) in order to maintain
water resistance.
• First unscrew the crown anti-clockwise from the
case to position
2
for winding in power. Wind in
a clockwise direction to re-power the watch.
Your C60 Trident has a maximum power reserve
of 48 hours when fully wound. Normal wearing
will allow the rotor to start re-powering the
watch over time after putting it on your wrist.
• For rapid date correction pull gently into position
3
and turn in a clockwise direction.
• Pull gently into position
4
for handsetting and
stopping of the second hand. For precise time
setting it is recommended to
pass beyond the desired minute and to set the
hand backwards.
PLEASE NOTE: Date correction should not be
carried out between 20.00 hr and 02.00 hr as
the watch gearing will already be aligning itself
to change the date.
You must always ensure the crown is fully
tightened before any use in water to prevent
moisture from entering the case.
To Next Page
Loading...
