chromagen MIDEA 170L User Manual

170L Heat
Pump: Quick
Start Guide
1
Position unit on a flat sturdy surface able
to bear the weight of a fully filled unit.
QUICK
START
INSTALLATION
GUIDE
MIDEA
HEAT PUMP
170 LITRE
Fit the condensation tube to the lower port on the rear of
the unit and run to suitable location.
Remove top cover (to access the electrical compartment)
by removing the locking screw and rotating in a clockwise
direction. Simply lift up to remove and put aside.
Connect the hot pipe, the cold pipe (ensure non-return valve is
used at the tank location) & connect PTR valve (drain to legal
point of discharge)
HEAT PUMP
PTR VALVE
INSTRUCTIONS
BOX CONTENTS
CONDENSATION TUBE
UV SCREEN COVER
FASCIA COVER

chromagen MIDEA 170L Specifications

General

Brand	chromagen
Model	MIDEA 170L
Category	Heat Pump
Language	English

Summary

Initial Installation Steps

Unit Placement

Position the unit on a flat, sturdy surface capable of supporting its full weight.

Condensation Tube Installation

Attach the condensation tube to the lower rear port and route it to a suitable location.

Accessing Electrical Compartment

Remove the top cover by releasing the locking screw and rotating clockwise.

Pipe and Valve Connections

Connect hot pipe, cold pipe (with non-return valve), and PTR valve to discharge point.

Electrical Connections and Startup

Wiring the Unit

Feed the cable through the access hole and connect to the electrical compartment.

Securing Top Cover

Reposition and rotate the top cover counter-clockwise to lock, securing with the screw.

Installing Fascia and Screen Covers

Fit fascia cover using locating pins and magnet, and attach UV Screen cover with tape.

Filling and Bleeding

Fill the heater with water and bleed air by opening a hot water tap.

Unit Operation and Mode Selection

Turn on the heater by pressing the button twice; set to 'economy mode' for efficiency.