LANESENSE
The LaneSense system can be enabled and disabled with the LaneSense button located on
the switch panel below the Uconnect® display.
• Push the LaneSense button to turn the system ON (LED turns off).
The LaneSense system is operational at speeds above 37 mph (60 km/h) and below 112 mph
(180 km/h). The LaneSense system uses a forward looking camera to detect lane markings and
measure vehicle position within the lane boundaries.
When both lane markings are detected and the driver unintentionally drifts out of the lane (no
turn signal applied), the LaneSense system provides a haptic warning in the form of torque
applied to the steering wheel to prompt the driver to remain within the lane boundaries. If the
driver continues to unintentionally drift out of the lane, the LaneSense system provides a visual
warning through the Electronic Vehicle Information Center (EVIC) or Driver Information
Display (DID) to prompt the driver to remain within the lane boundaries.
The driver may manually override the haptic warning by applying torque into the steering wheel
at any time.
When only a single lane marking is detected and the driver unintentionally drifts across the lane
marking (no turn signal applied), the LaneSense system provides a visual warning through the
Electronic Vehicle Information Center (EVIC) or Driver Information Display (DID) to prompt
the driver to remain within the lane. When only a single lane marking is detected, a haptic
(torque) warning will not be provided.
Refer to your Owner's Manual on the DVD for further details.
NOTE:
When operating conditions have been met, the LaneSense system will monitor if the driver’s
hands are on the steering wheel and provides an audible warning to the driver when the driver’s
hands are not detected on the steering wheel. The system will cancel if the driver does not return
their hands to the wheel.
OPERATING YOUR VEHICLE
62
To Next Page
Loading...
