Jacking Instructions
1.
Remove the scissors jack and lug wrench from
the spare wheel as an assembly. Turn the jack
screw to the left to loosen the lug wrench, and
remove the wrench from the jack assembly.
NOTE:
The jack handle attaches to the side of the jack with two attachment points. When the jack is
partially expanded, the tension between the two attachment points holds the jack handle in place.
2. Loosen, but do not remove, the wheel nuts
by turning them to the left one turn while
the wheel is still on the ground.
3. There is a front and rear jacking location on each side of the vehicle.
WHAT TO DO IN EMERGENCIES
78
To Next Page
Loading...
