Call Termination
To end a call in progress, momentarily press the but-
ton. Only the active call(s) will be terminated and if there
is a call on hold, it will become the new active call. If the
active call is terminated by the phone far end, a call on
hold may not become active automatically. This is cell
phone-dependent. To bring the call back from hold, press
and hold the
button until you hear a single beep.
Redial
• Press the button to begin.
• After the “Ready” prompt and the following beep, say
“Redial”.
• The Uconnect威 Phone will call the last number that
was dialed from your mobile phone.
NOTE: This may not be the last number dialed from the
Uconnect威 Phone.
Call Continuation
Call continuation is the progression of a phone call on the
Uconnect威 Phone after the vehicle ignition has been
switched to OFF. Call continuation functionality avail-
able on the vehicle can be any one of three types:
• After the ignition is switched to OFF, a call can
continue on the Uconnect威 Phone either until the call
ends, or until the vehicle battery condition dictates
cessation of the call on the Uconnect威 Phone and
transfer of the call to the mobile phone.
• After the ignition is cycled to OFF, a call can continue
on the Uconnect威 Phone for a certain duration, after
which the call is automatically transferred from the
Uconnect威 Phone to the mobile phone.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 123
To Next Page
Loading...
