EasyManua.ls Logo

Chrysler 2013 200 - Intermittent Wiper System

Chrysler 2013 200
509 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
NOTE: The wipers will automatically return to the park
position if you turn the ignition switch OFF while they
are operating. The wipers will resume operation when
you turn the ignition switch to the ON position again.
CAUTION!
Turn the windshield wipers off when driving
through an automatic car wash. Damage to the
windshield wipers may result if the wiper control
is left in any position other than off.
Always remove any buildup of snow that prevents
the windshield wiper blades from returning to the
off position. If the windshield wiper control is
turned off and the blades cannot return to the off
position, damage to the wiper motor may occur.
Intermittent Wiper System
Use the intermittent wiper system when weather conditions
make a single wiping cycle with a variable pause between
cycles desirable. Rotate the end of the windshield wiper/
washer control lever to the first detent, and then turn the
end of the lever to select the desired delay interval. There
are five delay settings, which allow you to regulate the wipe
interval from a minimum of one cycle every second to a
maximum of approximately 18 seconds between cycles.
Changing Intermittent Settings
172 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Information Provided by:

Table of Contents

Related product manuals