EasyManua.ls Logo

Chrysler 300 2015 - Drivers Automatic Dimming Mirror - if Equipped; Outside Mirrors with Turn Signal and Approach Lighting - if Equipped; Tilt Mirrors in Reverse - if Equipped; Power Mirrors

Chrysler 300 2015
660 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Driver’s Automatic Dimming Mirror
If Equipped
This feature is controlled by the inside auto-
matic dimming mirror and will automatically
adjust for headlight glare when the inside mirror
adjusts.
NOTE:
This feature is also available on the passen-
ger’s side when equipped with turn signal
and approach lighting.
Outside Mirrors With Turn Signal
And Approach Lighting If
Equipped
Driver and passenger outside mirrors with turn
signal and approach lighting contain four LEDs,
which are located in the upper outer corner of
each mirror.
Three of the LEDs are turn signal indicators,
which flash with the corresponding turn signal
lights in the front and rear of the vehicle. Turning
on the Hazard Warning flashers will also acti-
vate these LEDs.
The fourth LED supplies illuminated entry light-
ing, which turns on in both mirrors when you use
the Remote Keyless Entry (RKE) transmitter or
open any door. This LED shines outward to
illuminate the front and rear door handles. It
also shines downward to illuminate the area in
front of the doors.
The Illuminated Entry lighting fades to off after
about 30 seconds or it will fade to off immedi-
ately once the ignition is placed into the RUN
position.
NOTE:
The approach lighting will not function when
the gear selector is moved out of the PARK
position.
Tilt Mirrors In Reverse If
Equipped
Tilt Mirrors in Reverse provides automatic out-
side mirror positioning which will aid the driver’s
view of the ground rearward of the front doors.
The outside mirrors will move slightly downward
from the present position when the vehicle is
shifted into REVERSE. The outside mirrors will
then return to the original position when the
vehicle is shifted out of the REVERSE position.
Each stored memory setting will have an asso-
ciated Tilt Mirrors in Reverse position.
NOTE:
The Tilt Mirrors in Reverse feature is not
turned on when delivered from the factory.
The Tilt Mirrors in Reverse feature can be
turned on and off using the Uconnect® Sys-
tem. Refer to “Uconnect® Settings” in “Un-
derstanding Your Instrument Panel” for fur-
ther information.
Power Mirrors
The power mirror controls are located on the
driver’s door trim panel.
Power Mirror Control
68

Table of Contents