LICENSE PLATE LAMP – REAR BUMPER
FASCIA
REMOVAL
(1) Remove screws holding license plate lamp to
fascia (Fig. 19).
(2) Remove license plate lamp from vehicle.
INSTALLATION
(1) Place license plate lamp in position on vehicle.
(2) Install screws to attach license plate lamp to
fascia.
Fig. 17 Tail, Stop, Back up, and Turn Signal –
Intrepid
Fig. 18 Tail, Stop, Back up, and Turn Signal – 300M
Fig. 19 License Plate Lamp
1 – APPLIQUE OR FASCIA
2 – LICENSE PLATE LAMP
8L - 24 LAMPS LH
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
