Navigation
that you are aware of the dangers associated with the
use of this navigation equipment. The navigation sys-
tem will not operate until this prompt is confirmed,
Press the right knob to confirm the selection,
SELECTING NAVIGATION
ring data from the CD to the navigation system. E!I
will disappear. Once the route calculation has been
completed, you may remove the navigation CD and
insert an audiO CD.
MAIN NAVIGATION MENU
Press the" button. If necessary, confirm the
warning as described previously.
Next, the main navigation menu appears.
DES i. :'1Et'1CiR,,'
['EST !;~IHTI~)N
P.o ..I.
NOTE: When starting navigation mode for the first
time, you must load the navigation CD. The system will
prompt you to take a drive for calibration of the navi-
gation system if calibration has not been completed. If
this occurs, see System Calibration.
The navigation mode requires the navigation CD con-
taining the data for the destination.
E!I will flash
on the display during route calculation while transfer-
60
Select one of the following by turning the right knob
and pressing it to confirm.
• DESTINATION: Enter a destination using data
from the navigation CD.
• DEST. MEMORY: Select a destination from your
list of saved destinations, up to 50.
• P.O.I.: Enter a destination from the Points of Inter-
est information on the navigation CD. Points of
To Next Page
Loading...
