NOTE: In Autostick威 mode, the transaxle will only shift
up or down when the driver moves the shift lever to the
right (+) or left (-).
AutoStick威 is deactivated when the shift lever is moved
from the AutoStick (+/-) position into the DRIVE
position.
General Information
•
You can start out in 1st or 2nd gear. The system will
ignore attempts to upshift at too low of a vehicle
speed.
•
If a ratio other than 1st is selected, and the vehicle is
brought to a stop, the transaxle control logic will
automatically select the 1st gear ratio.
•
Starting out in 2nd gear is helpful in snowy or icy
conditions.
•
Avoid using speed control when Autostick威 is en-
gaged.
•
The transaxle will automatically shift up when maxi-
mum engine speed is reached while Autostick威 is
engaged.
•
Transaxle shifting will be more noticeable when
Autostick威 is engaged.
•
If a downshift would cause the engine to over-speed,
that shift will not occur until it is safe for the engine.
Mostly the transaxle will stay in the manually selected
ratio, however.
•
If the system detects powertrain overheating, the
transaxle will revert to the automatic shift mode and
remain in that mode until the powertrain cools off.
•
If the system detects a problem, it will disable the
AutoStick威 mode and the transaxle will return to the
automatic mode until the problem is corrected.
STARTING AND OPERATING 277
5
To Next Page
