APPLlCATIONS:
SIMPLE WEIGHING:
TARING:
ANIMAL WEIGHING:
SUBTRACTIVE WEIGHING:
BELOW BALANCE WEIGHING:
Press the TARE key. Allow reading to stabilize and " *" to
disappear before reading value.
Place an empty container on the weighing pan.
Press the TARE key and allow zero and
"*" to disappear from
the display. Place a sample in the container and record a sanple
weight when
"*" disappears.
Set SAP and STb funcitons to high values (SAP-A plus STb+ll,
STb-H2 or STb-H3l described in appropriate sections before
weighing.
Place a sample container on the weighing pan. Press the TARE
key and allow zero and
"*" to disappear from the display.
Remove a portion of the sample from the container. The weight
of the removed portion is displayed as a negative value.
For weight measurements below the balance, there is an optional
hanger (OMJ-l l .
=
.. ·Make certain the attachment wire is strong enough to
support the sample weight .
..·Check an alignment of a hanger to insure it hangs freely
at 011times.
.. ·Protect the hanger from drafts for best results.
This includs the lower portion of the balance between
the bottom of the balance and the table .
... When making normal measurements, the hanger should
be disconnected and the hole in the bottom of the
balance should be plugged.
-17-
To Next Page
Loading...