I CAL
I PASS
I CAL Err
I Uni-l
I oUt-l
I rS-8n 1
I rSS-1.2
I AST ON
CALIBRATION MODE:
Make certain the weighing pan is empty. The Calibration
sequence is started by pressing the TARE key. Donot
disturb the balance until calibration is complete.
See CALIBRATION section. page
11.
PASS:
Calibration rrode: Indicatescalibration sequenceis complete.
CALIBRATION ERROR:
Balance was unable to complete calibration sequence.
Check the CALIBRATION section. page 11.
UNIT SELECTION:
See UNIT SELECTION section. page 12.
OUTPUT DATA MODE:
See OUTPUT DATA MODE section. page 20.
RS-232C MODE:
See DATA OUTPUT INTERFACERS-232C section,
page 18.
BAUD RATE SPEED;
See DATA OUTPUT INTERFACERS-232C section.
page 18.
AUTo-ST ART MODE:
If auto-start mode is on, then balance will be weighing
position immediately without pressing the ON/STBY key.
-6-
To Next Page
Loading...