Cicada Audio DSP88 - Page 7

2
2021 Cicada Audio All rights reserved.
Introduction
SYSTEM DESIGN OPTION 1
REAR INPUT WITH
HD MOLEX WITH
47 OHM RESISTOR
(Can be used if bike is FLASHED)
DSP88 REAR INPUT:
CX150.4D (Fairing Mid/Tweeter Amp INPUT CH1/2/3/4)
BDA1600.4D
(Bag Woofer Amp INPUT CH7/8)
CX250.2D
(Bag FullRange Amp INPUT CH5/6)
12V 0.2V
AUTO
TURN ON
FREQ
30Hz
300Hz
PWR
PRT
CLIP
CH1/2
XOVER
12V 0.2V
CONFIG
FREQ
30Hz 300Hz
CH3
CH3/4
XOVER
2CH 4CH
CH4
POWER INPUT
+12V
REM GRD
BRIDGED
CH2CH1
CH3 CH4
BRIDGED
3 AMPLIFIERS /BI-AMPED
2 - 4 CHANNEL / 1 - 2 CHANNEL
REM
REM
REM
BDA1600.4D
(Bag Woofer Amp OUTPUT CH7/8)
CX150.4D
(Fairing Mid OUTPUT CH3/4 )
CX150.4D (Fairing Mid
OUTPUT CH1/2 )
CX250.2D
(Bag FullRange Amp OUTPUT CH5/6)
CM65.2 (6.5” 2 Ohm MidBass)
CH65.2 / CH69.2 / CH8.2
(6.5” 2 Ohm CoAx Horns)
CS8.4/CS10.4
(8 or 10” 4 Ohm MidWoofers)
AMP 1
AMP 2
AMP 3
CX150.4D (Fairing Mid
OUTPUT CH1/2/3/4 )
NOTE: DSP XOVER
SET AT BANDPASS
90 - 6kHz@12dB
NOTE: DSP XOVER
SET AT LOWPASS
90Hz @12dB
NOTE: DSP XOVER
SET AT 6kHz@12dB
HIGHPASS
NOTE: DSP XOVER
SET AT HIGHPASS
90Hz @12dB
8 CHANNEL / 3 AMP SYSTEM W / COmponent & HORNS / WOOFERS8 CHANNEL / 3 AMP SYSTEM W / COmponent & HORNS / WOOFERS
NOTE: SOME TYPE
OF LID KIT IS NEEDED
NOTE: MAKE SURE TO SEPERATE
THE WOOFER FROM THE COAX HORNS!!!
(AT LEAST “ACOUSTICALLY”)