- 12 -
▶ Direct connection with the servo driver via EtherCAT
- The fast communication speed (1 ms
–
1000 ms)
- With Ethernet cable, wiring is very simple.
- Highly compatible with various brands of servo driver and motors.
- Set up servo parameter by CICON
- CICON software enables a user to conduct a trial run and program operation for
PS08N.
▶ PS08N follows the EtherCAT standard CiA402 profile specifications.
- PS08N supports EtherCAT Slave Servo Drives from other manufacturers.
- The EtherCAT Slave Servo Drives that have been tested for trial runs are listed in
the table below.
If you have drivers other than the listed below, please contact the distributor or
headquarters that you have purchased the drives from.
Manufacturers Drive Name
Omron R88D – KN01H – ECT
LS XDL – L7NA001B
▶ PS08N offers various functions required for positioning systems such as
positioning and speed control.
- Position control (Absolute, Incremental)
- Velocity control
- Multi axes control
- Interpolation control (Linear, Circular (F/W ver.2.0 or more), helical (F/W ver.2.0
or more))
▶ Switching control is easily done during the operation.
- Position / Velocity Control Switch
- Velocity / Position Control Switch
- Position / Torque Control Switch (F/W ver.2.0 or more)
▶ PS08N saves the parameters and operation data to memory.
(No batteries required)
▶ A user can implement an absolute positioning system.
CM1-PS08N Features
To Next Page
Loading...