26
9. The shifting unit has to be centered into borehole of the inner demeshing
plate. Pay attention to not bending any parts such as the catch by improp-
er handling.
10. Rotate the housing cover around the locking screw until the outer
demeshing plate is fully visible. Position the outer demeshing plate
on the housing and center the borehole onto the shifting unit.
11. Rotate the housing cover back around the locking screw until flush with
the housing and tighten the housing cover screws with an Allen key using
a clamping torque of 2,5 Nm.
2,5 Nm
To Next Page
Loading...