Take one screw and one standoff, and fasten it. The screws have to go to the
outside of the casing and the standoffs to the inner side.
You'll recognize the sides by the six circles! On the outside, you'll be able to touch
the edges of the circle!
Repeat this for all of the six screws and standoffs:
Now, take the PCB and this acrylic casing, and let's connect everything!
Now, take the screwdriver and fasten the screws!
Beware not to screw it too hard because that could lead to the breaking of the
casing!
Everything is connected now! Amazing!
To Next Page
Loading...