Wall-Mounting the Router
Cisco 1600 Series Router Hardware Installation Guide
3-10
Wall-Mounting the Router
Cisco 1600 series routers can be wall-mounted by using two number-six, 3/4-inch screws
(not included) and the molded mounting brackets on the bottom of the router (see
Figure 3-7).
Caution If you install the screws in drywall, use hollow wall-anchors
(1/8 inch by 5/16 inch) to secure the screws. If the screws are not properly
anchored in wallboard or drywall, the strain of the network cable connections
could pull the router from the wall.
Figure 3-7 Wall-Mount Brackets (Bottom of Router)
Follow these steps to mount the router on a wall or other vertical surface, as shown in
Figure 3-8:
Step 1 Install the two screws 7.5 inches (19.05 centimeters) apart on a wall or other flat
surface.
Mounting
bracket
Mounting
bracket
Front panel of router
7.5" (19.05 cm)
Bottom
of router
H7235
To Next Page
Loading...
