1-2 Cisco 4000 Series Installation Guide
• Dual-port high-speed synchronous serial and 16-port low-speed
synchronous/asynchronous serial. The high-speed ports supports EIA/TIA-232,
EIA/TIA-449, V.35, X.21, NRZ/NRZI, DTE/DCE, or EIA-530 DTE interfaces. The
low-speed ports support EIA/TIA-232, V.35, or X.21 interfaces in DTE or DCE mode.
Each low-speed port can be individually configured for synchronous or asynchronous.
• Single-port HSSI
• Single-port and dual-port Token Ring
• Dual attachment single-mode FDDI
• Single attachment or dual attachment multimode FDDI
• Four-port or eight-port ISDN BRI
• Four-port balanced or unbalanced G.703/G.704
• Single-port channelized T1/ISDN PRI
• Single-port balanced or unbalanced channelized E1/ISDN PRI
• Single-port ATM with single-mode OC-3 and long-reach capability, multimode OC-3,
DS-3, or E3 interfaces
Note For information about modules released after publication of this guide, see the
configuration note packet shipped with your router.
Note EIA/TIA-232 and EIA-TIA-449 were known as recommended standards RS-232
and RS-449 before their acceptance as standards by the Electronics Industries Association
(EIA) and Telecommunications Industry Association (TIA)
Figure 1-1 shows the front panel of a Cisco 4000 series router.
Figure 1-1 Cisco 4000 Series Chassis—Front Panel
To Next Page