EasyManua.ls Logo

Cisco 4948 Series - Layer 3 Features; QoS and Traffic Management

Cisco 4948 Series
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
© 2006 Cisco Systems, Inc. All rights reserved.
Important notices, privacy statements, and trademarks of Cisco Systems, Inc. can be found on cisco.com.
Page 4 of 16
• Port Aggregation Protocol (PAgP)
• Unidirectional Link Detection Protocol (UDLD) and aggressive UDLD on the SFP ports
• Q-in-Q in hardware
• Layer 2 protocol tunneling
• Jumbo frames on all ports (up to 9216 bytes)
• Baby giants (up to 1600 bytes)
• Hardware-based storm control (formally known as broadcast and multicast suppression)
• Community private VLANs (PVLANs)
• Forced 10/100 autonegotiation
• Web Content Communication Protocol Version 2 Layer 2 Redirect
• Private VLAN Promiscuous Trunk
Layer 3 Features
• Hardware-based IP Cisco Express Forwarding routing at 72 Mpps
• Static IP routing
• IP routing protocols: EIGRP, OSPF, RIP, RIP2
• BGPv4 and Multicast Border Gateway Protocol (MBGP)
• Hot Standby Router Protocol (HSRP)
• Software routing of IPX and AppleTalk
• IS-IS routing protocol
• IGMPv1, v2, and v3
• IGMP filtering on access and trunk ports
• IP Multicast routing protocols (Protocol Independent Multicast [PIM], Source Specific Multicast [S SM], and Distance Vector
• Multicast Routing Protocol [DVMRP])
• Pragmatic General Multicast (PGM)
• Cisco Group Management Protocol (GMP) server
• Full Internet Control Message Protocol (ICMP) support
• ICMP Router Discovery Protocol
• Policy-based routing (PBR)
• Virtual Route Forwarding-lite (VRF-lite)
• IPv6 software switching support
• OSPF fast convergence
• EIGRP stub
• Virtual Router Redundancy Protocol (VRRP)
Sophisticated QoS and Traffic Management
• Per-port QoS configuration
• Per-port per VLAN QoS
• Support for four queues per port in hardware
• Strict priority queuing
• IP differentiated services code point (DSCP) and IP Precedence
• Classification and marking based on IP type of service (ToS) or DSCP
• Classification and marking based on full Layer 3 and 4 headers (IP only)
• Input and output policing based on Layer 3 and 4 headers (IP only)