To Next PageTo Next Page
Need help?Do you have a question about the Cisco C9200L-24P-4G and is the answer not in the manual?
General| Model | C9200L-24P-4G |
|---|---|
| Category | Switch |
| Ports | 24 x 10/100/1000 (PoE+) |
| Switching Capacity | 128 Gbps |
| Power Budget | 370W |
| Layer | Layer 3 |
| Enclosure Type | Rack-mountable |
| Subtype | Gigabit Ethernet |
| Power Over Ethernet (PoE) | PoE+ |
| RAM | 4 GB |
| Flash Memory | 4 GB |
| Power Device | Internal power supply |
| Voltage Required | AC 120/230 V (50/60 Hz) |
| Routing Protocol | OSPF, EIGRP, BGP, IS-IS, RIP |
| Remote Management Protocol | SNMP 1, SNMP 3, CLI, HTTP, SSH |
| Features | VLAN support, DHCP support, Quality of Service (QoS), IGMP snooping |
| Compliant Standards | IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3af, IEEE 802.3at, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p, IEEE 802.1x, IEEE 802.1s, IEEE 802.1w |
| Operating Temperature | 0 to 45 °C |
| Operating Humidity | 5% to 95% (non-condensing) |
Details the various Cisco Catalyst 9200 Series switch models and their supported features, including port configurations and stacking capabilities.
Details the functionality of Power over Ethernet (PoE) and PoE+ ports, including power delivery capabilities and standards compliance.
Provides an overview of the supported internal AC power supply modules, their specifications, and installation considerations.
Covers essential preparation steps before physically installing the switch, including initial setup considerations.
Lists crucial safety precautions and warnings to be observed during the installation and handling of the switch equipment.
Provides environmental and physical guidelines for installing the switch to ensure proper operation and longevity.
Explains how to power on the switch and verify its successful operation through the Power-On Self-Test (POST) process.
Details the procedures for physically installing the switch, including rack-mounting and shelf-mounting methods.
Provides instructions and guidelines for mounting the Cisco Catalyst 9200 Series switch into a standard 19-inch rack.
Describes the procedure for placing and securing the switch on a table or shelf, including attaching rubber feet.
Guides on connecting devices to the switch's Ethernet ports, including 10/100/1000 ports and PoE/PoE+ connections.
Details the process of connecting multiple switches together using StackWise cables and adapters for stacking configurations.
Highlights essential safety warnings and ESD precautions relevant to handling and installing network modules.
Details the step-by-step process for installing or replacing an AC power supply module in the Cisco Catalyst 9200 Series switch.
Step-by-step instructions for installing a new fan module into the Cisco Catalyst 9200 Series switch chassis.
Guides on initial switch setup and configuration via the Web User Interface (Web UI), including connecting and basic settings.
Details how to access and use the Command Line Interface (CLI) for switch configuration via console ports.
