To Next PageTo Next Page
Need help?Do you have a question about the Cisco C9200L-48P-4G and is the answer not in the manual?
General| Model | C9200L-48P-4G |
|---|---|
| Category | Switch |
| Uplink Interfaces | 4 x 1G SFP |
| Switching Capacity | 176 Gbps |
| PoE Budget | 740W |
| Stacking Bandwidth | 80 Gbps |
| Enclosure Type | Rack-mountable - 1U |
| Power Over Ethernet (PoE) | Yes |
| RAM | 2 GB |
| Flash Memory | 4 GB |
| Power Device | Internal power supply |
| Voltage Required | AC 120/230 V (50/60 Hz) |
| Ports | 48 x 10/100/1000 PoE+ |
| MAC Address Table Size | 16K |
| Jumbo Frame Support | Yes |
| Routing Protocol | RIP |
| Remote Management Protocol | SNMP |
| Features | Quality of Service (QoS), VLAN support, Access Control List (ACL) support, DHCP snooping, IPv6 support |
| Compliant Standards | IEEE 802.3, IEEE 802.3u, IEEE 802.3af, IEEE 802.3at |
| Operating Temperature | 0 to 40 °C |
| Operating Humidity | 10 to 90% non-condensing |
Details the different Cisco Catalyst 9200 Series switch models and their supported features.
Describes the components found on the front panel of the Cisco Catalyst 9200 Series switches.
Details the functionality of Power over Ethernet (PoE) and PoE+ ports.
Describes the ports used for connecting switches in StackWise stacking configurations.
Details the supported AC power supply modules and their specifications.
Explains the fan modules supported for cooling the Cisco Catalyst 9200 Series switches.
Explains how to power on the switch and verify its operation using POST.
Provides guidelines and considerations for planning and configuring switch stacks.
Details the rules and recommendations for creating and managing switch stacks.
Outlines the recommended sequence for powering on switches in a stack.
Provides instructions on how to mount the switch securely in a rack.
Describes the steps for physically mounting the switch into a rack.
Provides instructions for placing and securing the switch on a table or shelf.
Guides the user on how to connect switches using StackWise cables.
Explains how to connect network devices to the switch's Ethernet ports.
Describes how to connect devices that use Power over Ethernet (PoE) and PoE+.
Details the step-by-step process for installing a network module into the switch chassis.
Lists safety precautions and warnings specific to installing network modules.
Provides instructions for safely removing a network module from the switch.
Guides on installing and removing SFP and SFP+ modules.
Step-by-step instructions for installing or replacing an AC power supply module.
Guides the user through configuring the switch using the Web User Interface (WebUI).
Guides on configuring the switch using pre-defined site profiles for best practices.
Provides instructions for configuring the switch using the Command Line Interface (CLI).
