Cisco C9200L-48P-4G User Manual

Figure 8: Components delivered in the shipping box
8 number-8 Phillips flat-head screws8Cisco Catalyst 9200 Series switch
1
(power
supply modules are not displayed)
1
Cable guide9AC power cord2
M4.0 x 20mm Phillips pan-head screw10Product documentation and compliance
document
3
RJ-45 USB console cable
1
11Four rubber mounting feet4
(Optional) USB console cable
1
12Two 19-inch mounting brackets5
(Optional) StackWise cable
1
(0.5-meter,
1-meter, or 3-meter)
134 number-12 pan-head screw6
Power cord retainer144 number-10 pan-head screws7
1. Item is orderable.
Tools and Equipment
Obtain these necessary tools:
• A Number-2 Phillips screwdriver to rack-mount the switch
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
16
Installing the Switch
Tools and Equipment

Cisco C9200L-48P-4G Specifications

General

Model	C9200L-48P-4G
Category	Switch
Uplink Interfaces	4 x 1G SFP
Switching Capacity	176 Gbps
PoE Budget	740W
Stacking Bandwidth	80 Gbps
Enclosure Type	Rack-mountable - 1U
Power Over Ethernet (PoE)	Yes
RAM	2 GB
Flash Memory	4 GB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Ports	48 x 10/100/1000 PoE+
MAC Address Table Size	16K
Jumbo Frame Support	Yes
Routing Protocol	RIP
Remote Management Protocol	SNMP
Features	Quality of Service (QoS), VLAN support, Access Control List (ACL) support, DHCP snooping, IPv6 support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3af, IEEE 802.3at
Operating Temperature	0 to 40 °C
Operating Humidity	10 to 90% non-condensing