Cisco C9200L-48P-4G User Manual

CONTENTS
Product Overview 1
CHAPTER 1
Switch Models 1
Front Panel Components 2
10/100/1000 Ports 3
PoE and PoE+ Ports 4
Management Ports 4
USB Type A Port 5
Uplink Ports 5
Rear Panel 6
RFID Tag 8
StackWise Ports 8
Power Supply Modules 8
Fan Modules 9
Ethernet Management Port 10
RJ-45 Console Port 10
Network Configurations 11
Installing the Switch 13
CHAPTER 2
Preparing for Installation 13
Safety Warnings 13
Installation Guidelines 15
Shipping Box Contents 15
Tools and Equipment 16
Verifying Switch Operation 17
Planning a Switch Data Stack 17
Switch Stacking Guidelines 17
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
iii

Cisco C9200L-48P-4G Specifications

General

Model	C9200L-48P-4G
Category	Switch
Uplink Interfaces	4 x 1G SFP
Switching Capacity	176 Gbps
PoE Budget	740W
Stacking Bandwidth	80 Gbps
Enclosure Type	Rack-mountable - 1U
Power Over Ethernet (PoE)	Yes
RAM	2 GB
Flash Memory	4 GB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Ports	48 x 10/100/1000 PoE+
MAC Address Table Size	16K
Jumbo Frame Support	Yes
Routing Protocol	RIP
Remote Management Protocol	SNMP
Features	Quality of Service (QoS), VLAN support, Access Control List (ACL) support, DHCP snooping, IPv6 support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3af, IEEE 802.3at
Operating Temperature	0 to 40 °C
Operating Humidity	10 to 90% non-condensing