Cisco C9200L-48P-4G User Manual

Data Stack Cabling Configurations 17
Data Stack Bandwidth and Partitioning Examples 18
Power-On Sequence for Switch Stacks 20
Installing the Switch 21
Rack-Mounting 21
Attaching the Rack-Mount Brackets 22
Mounting the Switch a Rack 24
Installing the Switch on a Table or Shelf 24
After Switch Installation 25
Connecting to the StackWise Ports 25
Connecting Devices to the Ethernet Ports 27
10/100/1000 Port Connections 27
Auto-MDIX Connections 27
Auto-MDIX Connections 27
PoE and POE+ Port Connections 28
Installing a Network Module 31
CHAPTER 3
Installing a Network Module in the Switch 31
Safety Warnings 31
Equipment That You Need 31
Installing a Network Module 32
Removing a Network Module 34
Finding the Network Module Serial Number 34
Installing and Removing SFP Modules 35
Installing SFP/SFP+ Modules 35
Removing SFP/SFP+ Modules 37
Installing a Power Supply Unit 39
CHAPTER 4
Power Supply Modules Overview 39
Finding the Power Supply Module Serial Number 41
Installation Guidelines 42
Installing or Replacing an AC Power Supply Module 43
Installing a Fan Module 47
CHAPTER 5
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
iv
Contents

Cisco C9200L-48P-4G Specifications

General

Model	C9200L-48P-4G
Category	Switch
Uplink Interfaces	4 x 1G SFP
Switching Capacity	176 Gbps
PoE Budget	740W
Stacking Bandwidth	80 Gbps
Enclosure Type	Rack-mountable - 1U
Power Over Ethernet (PoE)	Yes
RAM	2 GB
Flash Memory	4 GB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Ports	48 x 10/100/1000 PoE+
MAC Address Table Size	16K
Jumbo Frame Support	Yes
Routing Protocol	RIP
Remote Management Protocol	SNMP
Features	Quality of Service (QoS), VLAN support, Access Control List (ACL) support, DHCP snooping, IPv6 support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3af, IEEE 802.3at
Operating Temperature	0 to 40 °C
Operating Humidity	10 to 90% non-condensing