Cisco C9200L-48P-4G User Manual

Figure 22: Network Module Serial Number Location
Installing and Removing SFP Modules
Installing SFP/SFP+ Modules
Before you begin
See the switch release notes on Cisco.com for the list of supported SFP and SFP+ modules. Use only supported
SFP/SFP+ modules on the switch. For the latest information about supported SFP and SFP+ modules, refer
to the Cisco Transceiver Modules Compatibility Information.
For information about installing, removing, cabling, and troubleshooting SFP/SFP+ modules, see the module
documentation that shipped with your device.
Class 1 laser product. Statement 1008
Warning
• Do not remove the dust plugs from the SFP/SFP+ modules or the rubber caps from the fiber-optic cable
until you are ready to connect the cable. The plugs and caps protect the module ports and cables from
contamination and ambient light.
• Removing and installing an SFP/SFP+ module can shorten its useful life. Do not remove and insert any
SFP/SFP+ module more often than is necessary.
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
35
Installing a Network Module
Installing and Removing SFP Modules

Cisco C9200L-48P-4G Specifications

General

Model	C9200L-48P-4G
Category	Switch
Uplink Interfaces	4 x 1G SFP
Switching Capacity	176 Gbps
PoE Budget	740W
Stacking Bandwidth	80 Gbps
Enclosure Type	Rack-mountable - 1U
Power Over Ethernet (PoE)	Yes
RAM	2 GB
Flash Memory	4 GB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Ports	48 x 10/100/1000 PoE+
MAC Address Table Size	16K
Jumbo Frame Support	Yes
Routing Protocol	RIP
Remote Management Protocol	SNMP
Features	Quality of Service (QoS), VLAN support, Access Control List (ACL) support, DHCP snooping, IPv6 support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3af, IEEE 802.3at
Operating Temperature	0 to 40 °C
Operating Humidity	10 to 90% non-condensing