Cisco C9200L-24P-4G User Manual

CONTENTS
Product Overview 1
CHAPTER 1
Switch Models 1
Front Panel Components 2
10/100/1000 Ports 3
PoE and PoE+ Ports 4
Management Ports 4
USB Type A Port 5
Uplink Ports 5
Rear Panel 6
RFID Tag 8
StackWise Ports 8
Power Supply Modules 8
Fan Modules 9
Ethernet Management Port 10
RJ-45 Console Port 10
Network Configurations 11
Installing the Switch 13
CHAPTER 2
Preparing for Installation 13
Safety Warnings 13
Installation Guidelines 15
Shipping Box Contents 15
Tools and Equipment 16
Verifying Switch Operation 17
Planning a Switch Data Stack 17
Switch Stacking Guidelines 17
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
iii

Cisco C9200L-24P-4G Specifications

General

Model	C9200L-24P-4G
Category	Switch
Ports	24 x 10/100/1000 (PoE+)
Switching Capacity	128 Gbps
Power Budget	370W
Layer	Layer 3
Enclosure Type	Rack-mountable
Subtype	Gigabit Ethernet
Power Over Ethernet (PoE)	PoE+
RAM	4 GB
Flash Memory	4 GB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Routing Protocol	OSPF, EIGRP, BGP, IS-IS, RIP
Remote Management Protocol	SNMP 1, SNMP 3, CLI, HTTP, SSH
Features	VLAN support, DHCP support, Quality of Service (QoS), IGMP snooping
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3af, IEEE 802.3at, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p, IEEE 802.1x, IEEE 802.1s, IEEE 802.1w
Operating Temperature	0 to 45 °C
Operating Humidity	5% to 95% (non-condensing)