Cisco C9200L-24P-4G User Manual

Data Stack Cabling Configurations 17
Data Stack Bandwidth and Partitioning Examples 18
Power-On Sequence for Switch Stacks 20
Installing the Switch 21
Rack-Mounting 21
Attaching the Rack-Mount Brackets 22
Mounting the Switch a Rack 24
Installing the Switch on a Table or Shelf 24
After Switch Installation 25
Connecting to the StackWise Ports 25
Connecting Devices to the Ethernet Ports 27
10/100/1000 Port Connections 27
Auto-MDIX Connections 27
Auto-MDIX Connections 27
PoE and POE+ Port Connections 28
Installing a Network Module 31
CHAPTER 3
Installing a Network Module in the Switch 31
Safety Warnings 31
Equipment That You Need 31
Installing a Network Module 32
Removing a Network Module 34
Finding the Network Module Serial Number 34
Installing and Removing SFP Modules 35
Installing SFP/SFP+ Modules 35
Removing SFP/SFP+ Modules 37
Installing a Power Supply Unit 39
CHAPTER 4
Power Supply Modules Overview 39
Finding the Power Supply Module Serial Number 41
Installation Guidelines 42
Installing or Replacing an AC Power Supply Module 43
Installing a Fan Module 47
CHAPTER 5
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
iv
Contents

Cisco C9200L-24P-4G Specifications

General

Model	C9200L-24P-4G
Category	Switch
Ports	24 x 10/100/1000 (PoE+)
Switching Capacity	128 Gbps
Power Budget	370W
Layer	Layer 3
Enclosure Type	Rack-mountable
Subtype	Gigabit Ethernet
Power Over Ethernet (PoE)	PoE+
RAM	4 GB
Flash Memory	4 GB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Routing Protocol	OSPF, EIGRP, BGP, IS-IS, RIP
Remote Management Protocol	SNMP 1, SNMP 3, CLI, HTTP, SSH
Features	VLAN support, DHCP support, Quality of Service (QoS), IGMP snooping
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3af, IEEE 802.3at, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p, IEEE 802.1x, IEEE 802.1s, IEEE 802.1w
Operating Temperature	0 to 45 °C
Operating Humidity	5% to 95% (non-condensing)