Cisco 6400 - Page 22

5-22
Cisco 6400 Hardware Installation and Maintenance Guide
OL-2133-02
Chapter 5 Maintaining the Cisco 6400
Replacing an NRP Module
Figure 5-17 NRP-2SV Fiber-Optic Cable Management
Step 9 Install blank filler panels to cover any unused slots. Use two retaining screws to secure each filler panel.
Replacing an NRP-1 Module SIMM
This section describes how to remove and replace an NRP-1 SIMM module.
General SIMM Information
SIMMs are sensitive components that are susceptible to ESD damage. Handle SIMMs by the edges only;
avoid touching the memory modules, pins, or traces (the metal “fingers” along the connector edge of the
SIMM).
Figure 5-18 shows the locations of the DRAM and Flash SIMMs on the NRP-1 module. The procedures
for removing, installing, and verifying the DRAM and Flash SIMMs are identical.
Caution To upgrade DRAM, you must install identical SIMMs in both DRAM SIMM connectors.
36225
NRP
STATUS
FAIL
NSP
CON
AUX
ETH
ACT
LNK
POWER
FAULT
MISWIRE
FANS
OK
FAN
FAILURE
MULTI-
FAN
FAILURE
1
2
3
4
0A
PROCESSOR ONLY
0B
56
7
8
SUB
SLOT
0
PCMCIA
NSP
CON
AUX
ETH
ACT
LNK
Slot 1
Slot 0
ACO
CRITICAL
MAJOR
MINOR
ALARMS
STATUS
FAIL
SUB
SLOT
1
CON
AUX
NRP
FAIL
STATUS
FE
LNK
ACT
FE
LNK
ACT
CON
AUX
FE
LNK
ACT
FE
LNK
ACT
OC-3
STM-1
PORT 0
PORT 1
STATUS
TX
FAIL
RX
STATUS
TX
RX
OC-3
STM-1
PORT 0
PORT 1
STATUS
TX
FAIL
RX
STATUS
TX
RX
OC-3
STM-1
PORT 0
PORT 1
STATUS
TX
FAIL
RX
STATUS
TX
RX
OC-3
STM-1
PORT 0
PORT 1
STATUS
TX
FAIL
RX
STATUS
TX
RX
PROCESSOR ONLY
POWER
FAULT
MISWIRE
OC-3
STM-1
PORT 0
PORT 1
STATUS
TX
FAIL
RX
STATUS
TX
RX
OC-3
STM-1
PORT 0
PORT 1
STATUS
TX
FAIL
RX
STATUS
TX
RX
OC-3
STM-1
PORT 0
PORT 1
STATUS
TX
FAIL
RX
STATUS
TX
RX
OC-3
STM-1
PORT 0
PORT 1
STATUS
TX
FAIL
RX
STATUS
TX
RX
OC-3
STM-1
PORT 0
PORT 1
STATUS
TX
FAIL
RX
STATUS
TX
RX
OC-3
STM-1
PORT 0
PORT 1
STATUS
TX
FAIL
RX
STATUS
TX
RX
NRP-2
When hot swapping this fan tray,
removal and replacement must
be done in under two minutes or
system shutdown will occur.
CAUTION
PCMCIA
Slot 1
Slot 0
ACO
CRITICAL
MAJOR
MINOR
ALARMS
STATUS
FAIL