Cisco 7201 Datasheet

Data Sheet
All contents are Copyright © 1992–2007 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information. Page 7 of 10
●
PA-T3+
●
PA-A3-OC3MM
●
PA-A3-OC3SMI
●
PA-A3-T3
●
PA-A3-E3
Note: The PAs with the following part numbers are available in Cisco IOS Software Releases
12.4T and 12.2SRC (upcoming release):
●
PA-MC-T3-EC
●
PA-MC-2T3-EC
●
PA-T3/E3-EC
●
PA-2T3/E3-EC
Note: The PAs with the following part numbers are available in Cisco IOS Software Releases
12.4T
●
SA-VAM2+
Product Specifications: Power Requirements
Table 3 gives the power requirements of the Cisco 7201.
Table 3. Power Requirements of Cisco 7201
Dual AC power supply information Dual AC Power Supply Information
Input power 150W maximum
Typical input power 85W
Input voltage rating 100 to 240 VAC wide input with power factor correction
Input current rating 2A maximum
Typical input current 0.85A at 100 VAC
0.35A at 240 VAC
Input frequency rating 50/60 Hz
Input cable Use only Cisco agency approved power cords
Dual DC power supply information Dual DC power supply information
Input power 150W maximum
Typical input power 85W
Nominal input voltage rating –48 and –60 VDC
Input current rating 6A maximum
Typical input current 1.8A at –48 VDC; 1.4A at –60 VDC
Input cable 16-AWG (1.0mm) or 18-AWG (0.75mm) wire with a circuit breaker rating of 20A
maximum; the ground wire must be at least as large as the supply wires

Cisco 7201 Specifications

General

Brand	Cisco
Model	7201
Category	Network Router
Language	English